This Tutorial is about flashing firmware on your Samsung Galaxy Ace S5830. I posted a step by and easy tutorials , please read complete guide once and then apply , if you skip any step then it can cause of bricked phone.
Disclaimer: Please remember that
flashing your mobile phone is fully on your own risk. If the process is
interrupted (power failure, disconnected cable, software failure (e.g.
with KIES) ) your phone might be very difficult to revive. . Follow this
Guide on your risk and if your device gets damaged or bricked during
the process, This Samsung Galaxy Series will not be responsible..
(I) Preparing Your phone
1. Go to settings>>applications>>development and enable usb debugging2. Follow this guide – Preparing your Android phone before upgrading / installing firmware
If you have rooted phone or using any custom ROM Then
you will have to clear cache and wipe data which can done by booting
your phone in recovery mode and select Wipe data/factory reset and also select wipe cache partition
(II) Download required things
- Download ODIN v4.38 – it is a tool that is used to flash firmware on your phone
- Drivers – Download and install drivers that are required to detect your phone by pc
- Download Firmware for your phone
- Download .OPS File
- An Archive (.zip / .rar) file extractor, usually all pc owners have this tool . In case you don’t have any use 7zip archive extractor
(III) Instructions to Install Firmware on Galaxy Ace S5830
- First extract SAMSUNG_USB.rar and install drivers on pc
- Extract Firmware files on safe place, you will get some .tar files , please don’t extract .tar files
- Run S5570_Odin Multi Downloader v4.38.exe by right click and select run as administrator
- Make sure you have Auto Reboot and Protect OPS checked
- Click on OPS tab and select the Cooper_v1.0.ops file
- Now its time to Select .tar files from firmware folder,
=>(A) If you got three or more files then
Click on BOOT tab and select file with APBOOT in the name
Click on PDA tab and Select .tar file with CODE / PDA in the name
Click on PHONE tab and Select .tar file with MODEM in the name
Click on CSC tab and Select .tar file csc / csc-multi in the name
Leave EFS blank
(See Image below carefully to understand which files to select)
=>(B) If you got only single files , then
Tick One Package from options and select single .tar file in one package tab
- Switch off your phone
- Now boot it in download mode , to do that press & hold volume down and middle key and while holding both press power on key
if your phone is unable to boot in download mode don’t proceed to next step ,please try again until it boot in download mode
- When entered in download mode connect your phone to pc with the help of usb cable
- You will see ID:COM section turn yellow and in message boxes “ADDED” appears, that means your phone is ready to start flashing process
- Now Click on “START” Button
- Do not disconnect the cable or turn off the device, when flashing
process will complete you will see a blue pass button , it will reboot
when it finishes.
(IV) Clearing Cache Data
- boot your phone in recovery mode ,to do that press and hold MIDDLE KEY + POWER ON
- you will see your phone booted in recovery mode , in recovery mode touch screen will not work so use volume UP and Down navigate through options and MIDDLE KEY to confirm
- choose “wipe cache partition” from menu
- it will clear the cache data
- now select reboot system now